Stihl RM 545 Manuel D'utilisation page 60

RM 545.0 VR:
Roller diameter (rear) 90 mm
Roller drive Vario
Weight 30 kg
Sound emissions
In accordance with Directive 2000/14/EC:
Guaranteed sound
power level L 95 dB(A)
WAd
In accordance with Directive 2006/42/EC:
Sound pressure level
at workplace L 82 dB(A)
pA
Uncertainty K 2 dB(A)
pA
Hand-arm vibrations
Specified vibration characteristic in
accordance with EN 12096:
Measured value a 4,20 m/sec²
hw
Uncertainty K 2,10 m/sec²
hw
Measurement in accordance with
EN 20643
Transporting lithium-ion batteries:
RM 545.0 VE: The lithium-ion batteries
used meet the requirements specified in
UN manual ST/SG/AC.10/11/Rev. 5
Part III, subsection 38.3.
The user may carry these batteries to the
place of use of the machine without further
restrictions during road transport.
Country-specific legislation must be
observed in the case of air or sea
transport.
For further transport instructions, see
http://www.stihl.com/safety-data-sheets
58
19. Troubleshooting
If necessary, contact a specialist
dealer; STIHL recommends STIHL
specialist dealers.
@ See engine instruction manual.
Fault:
Engine not starting
Possible cause:
– Motorstop lever not pressed.
– RM 545 VE: Battery discharged or
defective.
– No fuel in tank; fuel line blocked.
– Inferior, dirty or old fuel in tank.
– Air filter dirty.
– Spark plug socket detached from spark
plug; ignition lead not properly fastened
to socket.
– Spark plug dirty or damaged; incorrect
electrode gap.
– Lawn mower housing blocked.
Remedy:
– Press motorstop lever to handlebar and
hold. ( 9.2)
– RM 545 VE: Charge or replace battery.
( 8.6)
– Top up fuel; clean fuel line.
– Always use fresh, good quality fuel,
unleaded petrol; clean carburettor.
– Clean air filter.
– Connect spark plug socket; check
connection between ignition lead and
socket.
– Clean or replace spark plug; adjust
electrode gap.
– Clean lawn mower housing (disconnect
spark plug socket first) and additionally
remove battery on RM 545 VE.
( 12.2)
Fault:
Starting problems or deteriorating engine
power.
Possible cause:
– Lawn mower housing blocked.
– Mowing at an excessively low cutting
height or propulsion speed is too high in
relation to the cutting height.
– Water in fuel tank and carburettor;
carburettor blocked.
– Fuel tank contaminated.
– Air filter dirty.
– Spark plug dirty.
Remedy:
– Clean lawn mower housing (disconnect
spark plug socket first) and additionally
remove battery on
RM 545 VE. ( 12.2)
– Select higher cutting height or reduce
pushing speed. ( 8.5)
– Empty fuel tank, clean fuel line and
carburettor.
– Clean fuel tank.
– Clean air filter.
– Clean spark plug.
Fault:
Mowing channel blocked
Possible cause:
– Mowing blade is worn.
– Mowing grass which is too long or too
wet.
Remedy:
– Replace mowing blade. (
– Adapt cutting height and mowing speed
to mowing conditions. (
0478 111 9940 A - EN
12.4)
10.), ( 8.5)