z21 DUAL BOOSTER Manuel D'utilisation page 44

Z21 Booster
_
With the Default Werte (default values) button, you can restore the factory default settings of the
Z21-Boosters in the entry fields in the dialogue window.
With Lesen (read), the settings can be read out of the Z21-Boosters and displayed.
With Schreiben (write), the values in the entry fields are transferred to the Z21-Boosters.
With FW Update, the firmware in the Z21-Boosters can be updated. The target version or information
concerning the progress of the update respectively is shown in the Update Info field.
In the interest of further development, we reserve the right to make improvements and extensions with
regard to the settings.
Configuration using POM write commands
The Z21-Boosters can also be configured using POM programming commands as long as it is configuration
mode. Should the Z21-Boosters be connected via the B-Bus or the CDE port, it is only able to accept POM
write commands. If the Z21-Boosters is connected via the CAN-Bus, it is possible to read the configura-
tions via POM.
The POM programming ("Programming on Main" = programming on the main track) normally serves to
enable the programming of the locomotive decoder to be carried out at the main track. The Z21-Boosters
can respond to these POM programming commands by way of exception when it is in configuration mode
– and only then – as long as these are directed at the "locomotive address" 9806. Should you coinci-
dentally have a locomotive with this address, please remove it from the track beforehand if necessary.
Switch the booster to configuration mode by pressing the STOP button for at least 2 seconds until the
status LED starts to flash green or red. Now release the button.
You can now change the settings by entering the following CV variables in the pseudo "locomotive ad-
dress" 9806 via POM using a WLAN-MULTIMAUS, MULTIMAUS or another input device of your choice:
CV-Nr. Meaning
7 Firmware Major Version
8 Manufacturer code;
CV 8=8  Restore works settings
10
CV 10=0  Quit configuration mode and return to
normal mode
65 Firmware Minor Version
44
44
r / w (CAN) Value
read only
read / write 161
only / write 0
read only