Dogtra PATHFINDER2 Serie Manuel Du Propriétaire page 16

Creating the E-Fence
Click on Set E-Fence Boundary.
Setting up Outer Fence
1) Press the button for the Outer Fence.
2) Move the map and place the on the desired area.
3) Click 'Drop Point' to create a point for the fence boundary.
4) Repeat the process above to complete the boundary. Create the fence so it
goes in one direction.
5) Click the save button on the top right. Only one can be saved.
Setting up Inner Fence
1) The Outer Fence must be created first to create the Inner Fence.
2) Press the button for the Inner-Fence.
3) Drag the area of the map you want to create the fence to the center
with the .
4) Click 'Drop Point' to create a point for the fence boundary.
5) Repeat the process above to complete the boundary. Create the fence so it
goes in one direction.
6) Click the save button on the top right. Three can be saved.
- You can create 1 Outer-Fence and 3 Inner-Fences. All fences can use up to 15
points.
28
Syncing E-Fence Boundary to the Receiver
In order to operate the E-Fence, the receiver must
be synced.
1) Turn the receiver on near the smartphone.
2) Press the Sync E-Fence Boundary button.
3) Look at the list to make sure the receiver is
synced.
Notes:
• After changing the E-Fence boundary, you
must sync it again.
• Each receiver must be synced individually in
order for the E-Fence to operate.
Applying Stimulation on the Receiver
1) Press the ▼ button for the receiver on the menu.
2) Set the stimulation level.
3) Press update.
Notes:
Go to E-Fence Settings to press the Activate
button to turn the E-Fence operation on or off
for each receiver.
E-Fence Alarm Setting
- Set the E-Fence Alarm Setting by going to
MENU SETTING E-FENCE.
- You can create an alarm for both exiting and
entering the E-Fence.
- You can select different alarm types.
29