Dogtra PATHFINDER2 Serie Manuel Du Propriétaire page 15

About the E-Fence
Correction
Pager vibr a tion
for 5 sec onds
for 5 sec onds
OUT
NEAR
No Corr ection
IN
OUT: When moving out of the boundaries, the e-collar emits Constant
1
correction for 5 seconds.
NEAR: The receiver emits a Pager vibration for 5 seconds when within 5
2
yards of the Outer Fence or Inner Fence.
IN: Safe area with no correction.
3
Outer Fence: One large fence on the outskirts.
4
Near Area: Automatically created within 4,50 metres of the Inner and
5
Outer Fence.
Inner Fence: Up to 3 Inner Fences can be created in the Outer Fence.
6
Notes:
For the dog's safety, the stimulation will only last 5 seconds if the dog goes
out of the boundaries. Make sure your dog comes back in the boundary after
5 seconds.
Restrictions:
Boundary design requires following:
1 - Minimum 850 m² area (If adding the Inner
4
Fence, need minimum 1700 m²area).
- Minimum distance of 20 metres between
each Drop Point.
850 m
2
3
26
Outer Fence
4,50 m
OUT
1
3
4
2
The fence boundary design
cannot cross over.
Notes:
When the E-Fence feature is turned on, the receiver synced with the latest
E-Fence boundary will have a blue LED. If there is no blue LED, sync the
receiver to the boundary by referring to "Syncing E-Fence Boundary to the
Receiver" on page 78.
1
3
2
Small Angle
The fence boundary design
cannot have sharp pointed areas
with small angles.
- ON/OFF: The E-Fence can be turned on/
off by toggling the button. When turned
on, the E-Fence Outer Fence shows up
and a blue light on the receiver turns on.
: E-Fence On Mark
- Status: Current receiver status of IN,
NEAR, or OUT. 'Need to update' will
show up if you need to update the latest
E-Fence boundary information.
- Count: The number of times the receiver
crossed the boundary.
- Stim Lvl: Displays the correction level
when activated. If it is not activated,
it will show OFF and you will need to
go to E-Fence Settings to activate the
stimulation setting.
27