DEVICE INFORMATION
1. RECEIVER FITTING
Proper Fit
Fit the receiver on either side of the dog's windpipe so that the contact points
press firmly against the dog's skin. You should be able to fit two fingers
underneath the collar strap.
Improper Fit
A loose fit can allow the receiver to move around on the dog's neck and cause
irritation. If the receiver is too loose, the contact will be inconsistent and cause
inconsistent correction.
Attention!
While Dogtra uses medical grade stainless steel contact points and anti-
microbial plastic to protect the dog's skin, leaving the receiver in the same
location for an extended period of time can cause skin irritation due to the
sensitivity from the contact points. Reposition the receiver every few hours
to move the contact points and remove the receiver after 8 hours of use.
Check for skin irritation each time you use the unit.
34
2. FINDING THE RIGHT STIMULATION
• Open the PATHFINDER2 app to the E-Collar tab and select your dog and
stimulation level.
• The stimulation levels are from 1 (lowest) to 100 (highest).
• Always start at the lowest level of stimulation and work your way up.
• The appropriate level can be found when your dog responds to the stimulation
with a mild reaction, such as a tensing of the neck muscles.
Note: Every dog has a different tolerance and reaction to the stimulation.
Please look at your dog's reaction to find the right level of stimulation. The
stimulation level may vary depending on the situation and distractions. A
distracted dog will require a higher level of stimulation compared to when
there is no distraction.
35