Dogtra PATHFINDER2 Serie Manuel Du Propriétaire page 24

FCC WARNING FOR PT20C/PR20C/PM20C
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The PATHFINDER2 complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
This is a sensitive radio device. Any unauthorized changes or modifications to this device
that are not expressly approved by Dogtra will void the warranty and may void the user's
authority to operate the equipment. Please do not tamper or modify the unit.
Radio frequency Radiation Exposure for PT20C
This portable transmitter with its antenna has shown compliance with FCC's SAR limits
for general population/ uncontrolled exposure. The maximum listed SAR level is 2.55
W/kg (Limb). The antenna used for this device must not be co-located or operating in
conjunction with any other antenna or transmitter.
Radio frequency Radiation Exposure for PR20C/PM20C
To comply with FCC RF exposure compliance requirements, a separation distance of at
least 11cm must be maintained between the antenna of this device and all persons. This
device must not be co-located or operation in conjunction with any other antenna or
transmitter. Any changes or modifications (including the antenna) made to this device that
are not expressly approved by the manufacturer may void the user's authority to operate
the equipment.
IC RESTRICTIONS
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is Subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired Operation of the device.
IC RF Radiation Exposure Statement: (PR20C/PM20C)
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance
of 17cm between the radiator and your body.
IC SAR warning: (PT20C)
The highest SAR value reported under this standard during product certification for use in
the hand is 2.55 W/kg.
44
WARRANTY AND REPAIR INFORMATION
LIMITED WARRANTY
For Dogtra Products Purchased from Dogtra Authorized Dealers
Two-Year Limited Warranty
Dogtra-Canada provides the original purchaser with a 2-YEAR LIMITED
WARRANTY for the products sold by Dogtra-Canada and its authorized
distributors/retailers. The warranty begins from the date of the original
purchase. The replaceable batteries of YS100, iQ No Bark Collar, iQ CLiQ and
BALL TRAINER are not covered by Warranty.
* The cost of shipping products under warranty back to Dogtra-Canada is the
customer's responsibility. Dogtra-Canada will provide/pay (via regular ground
service) the shipping cost back to the customer. Any expedited shipping service
will be at the customer's expense.
If a repair is not covered by warranty, the cost of Parts, Accessories, Labor fees,
and Shipping fees incurred are the customer's responsibility. Labor fees will be
variable depending on the extent of the work required.
To Qualify for the Dogtra Warranty
A proof of purchase is required to initiate repair work under warranty.
We strongly recommend keeping the original receipt.
Not Covered Under Warranty
Dogtra-Canada DOES NOT cover the cost of repairs and replacements due
to misuse by the owner or dog, improper maintenance, and/or lost units. Any
water damage on the Water Resistant Transmitters of the Dogtra 175NCP,
180NCP, 200NCP, 400NCP, 410NCP, iQ PLUS, iQ CLiQ and BALL TRAINER and
the Water Resistant Receivers of the RRS, RRD, RR Deluxe and BALL TRAINER,
will not be covered. All replacement costs for either the transmitter or receiver
will be the owner's responsibility. The warranty does not cover failure resulting
from damage, abuse or loss of parts. The warranty is void if the unit has been
altered or an unauthorized person has damaged the unit while attempting repair
work. Battery replacement by the customer during the warranty period is not
recommended. If the customer chooses to replace the batteries, any damage to
the unit during the change-out by the owner will void the warranty. The removal
of serial numbers from any Dogtra products will void the warranty. Dogtra
reserves the right to retain and discard any parts or accessories that have been
found damaged upon replacement and repair.
Out of Warranty Repair Work
For repair work that is no longer covered by warranty, the cost of repair will
include parts, labor and shipping. The owner will be informed about the repair
costs before the product is repaired. Write a note briefly explaining the problem.
Include your name, address, city/zip code, phone number and email address.
45