Dogtra PATHFINDER2 Serie Manuel Du Propriétaire page 14

2) Geo-Fence (Notification Only)
- Create Geo-Fences for specific areas to get alerts
on your device.
- Status: Indication of receiver in or out of the fence.
- Count: Number of times the receiver has crossed
the fence.
- Set the Geo-Fence Alarm Setting by going to
MENU
Notes:
• The Geo-Fence gives a notification on the
smartphone, but does not auto-correct the
e-collar.
• The automatic e-collar correction will only
work on the E-Fence.
Setting up a Geo-Fence
1. Press the button.
2. Move the map and place the on the desired area.
3. Click 'Drop Point' to create a point for the fence boundary, then repeat this
step to drop the next point.
4. Press Undo to delete the last point.
5. Click the save button on the top right.
- You can create up to 15 Drop Points and up to 15 Geo-Fences.
- Edit and delete file names and fence locations in the Fence List.
24
SETTING GEO-FENCE.
Geo-Fence Alarm Setting
- You can create an alarm for both exiting and
entering the Geo-Fence.
- You can select different alarm types.
3) E-Fence (Auto-Correction)
Set up the static E-Fence boundary to auto-correct your dog and get
notifications on your phone. When using the E-Fence, keep in mind:
- This device is GPS operated and cannot be used indoors.
- Do not use this as a permanent fence solution as your dog can still cross the
Outer Fence. Previous retriever training is needed to train your dog to come
back over the Outer Fence.
- The receiver will not emit stimulation when bringing your dog back over the
Outer Fence to the IN area.
- Make sure that Bluetooth is on to sync your receiver to the E-Fence boundary.
- Make sure that when the E-Fence boundary is updated, the receiver is synced
again.
- A smartphone or GPS connection is not needed to operate, but the track
information and application notification will not be received.
25