Resetting The Filter Display; Deactivating The Filter Display - Gaggenau RF 411 Guide D'utilisation Et D'entretien

1. Rotate the filter cap on the base panel by 90°–180°
in an anti-clockwise direction.
2. Pull the used filter cartridge out of the appliance.
3. Remove the cap from the used filter.
Take a new filter cartridge out of the packaging and remove
the protective cap.
4. Push the cap onto the new filter cartridge.
5. Push the filter cartridge with the cap in a horizontal
position all the way into the opening in the base panel.
6. Rotate the filter cartridge by 90°–180° gently in a clock-
wise direction until the cap is in a horizontal position.
After changing the filter, reset the filter display.
The appliance might be used without a water filter. If you
choose this option replace the water filter by a water filter
substitute cartridge. In this case the filter display might be
deactivated to prevent filter change messages.
To purchase a water filter substitute cartridge contact
your local dealer or call 1-800-578-6890.
NOTE
NOTE

Resetting the filter display

If the filter display is not reset, the next required filter
change cannot be signalled by the display.
After each filter change:

Simultaneously hold down the FAST FREEZING
:
ICE buttons for 3 seconds.

Deactivating the filter display

m
WARNING
To avoid serious illness or death, do not deactivate
the filter display while using an water filter.
To deactivate the filter display:

Simultaneously hold down the SETUP
buttons for 3 seconds.
Re-activate the filter display by pressing the FAST
3
FREEZING and ICE
simultaneously.
NOTE
W
and ICE
NOTE
:
buttons for 3 seconds
3
and
m
:
25