Installing And Connecting The Appliance; Connecting The Water; Connection To The Power Supply - Gaggenau RF 411 Guide D'utilisation Et D'entretien

Masquer les pouces Voir aussi pour RF 411:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installing and connecting the appliance

m
CAUTION
Have the appliance installed by an electrician according to
the enclosed installation instructions.
After installing the appliance, wait at least 8 hours before
switching on the appliance. During transit the oil
in the refrigeration system may have moved.
Before switching on the appliance for the first time, clean
the inside of the appliance.
Always connect the water before the power.
Apart from statutory national regulations, you should adhere
to the connection terms applied by local electricity and water
companies.
Do not remove the transportation protection devices from
the shelves and storage compartments until the appliance
has been installed.

Connecting the water

A cold water connection is required for operation
of the automatic ice maker. The water pressure must
be between 25 and 120 p.s.i. (1.72–8.25 bar).
The installation must comply with local plumbing regulations
and local and state laws.
A separate shut-off valve must be installed for the appliance
water connection.
The shut-off valve for the water connection must not
be behind the appliance. It is recommended to place
the shut-off valve directly next to the appliance (base unit)
or in another easily accessible location.
10

Connection to the power supply

m
m
Avoid Electrical Shock Hazard
– Plug into a grounded 3 prong outlet.
– Do not remove ground prong.
– Do not use an adapter.
– Do not use an extension cord.
Failure to follow these instructions can result in death, fire,
or electrical shock.
Improper connection of the equipment grounding
conductor may result in electric shock. Have the appliance
checked by a qualified electrician or service technician
if you are in doubt as to whether the appliance has been
properly grounded.
The appliance comes with an UL listed, 3-wire power supply
cord.
The appliance requires a 3-wire receptacle.
The receptacle must be installed by a licensed electrician
only.
The receptacle must be fitted with a 10 to 16 A fuse.
Please observe in this coherence the following table:
Appliance
Freezer 18"
Freezer 24"
Freezer 30"
WARNING
Maximal load at one time
3.5 Ampere
4.0 Ampere
4.5 Ampere
m

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rf 461Rf 463Rf 471

Table des Matières