Removing And Cleaning The Pitcher Holder; Removing And Cleaning The Ice Cube Container; Childproof Lock; How To Save Energy - Gaggenau RF 411 Guide D'utilisation Et D'entretien

Removing and cleaning the pitcher holder

Spilled water collects in the water collecting tray
of the pitcher holder. The water collecting tray can be
emptied and cleaned by pulling out the pitcher holder.
Removing and cleaning the ice cube
container
If ice cubes have not been dispensed for a prolonged period,
they will shrink, have a stale taste and stick together.

Pull out the ice cube container.
A filled container is heavy!

Empty the container and clean with lukewarm water.

Thoroughly rub the container and endless screw
transportation mechanism (Agitation function) dry so
that new ice cubes cannot freeze to them.

To re-insert push the ice cube container all the way back
onto the supports until it locks into position.

If the container cannot be pushed all the way back,
twist the screw conveyor in the container.

Childproof lock

To prevent against unintended use activate the childproof
lock.

Press the LOCK OUT button on the dispenser key panel
for 3 seconds.
Re-activate the dispenser buttons:

Press the LOCK OUT button for 3 seconds again.

How to save energy

– Install the appliance in a dry, ventilated room;
do not expose to direct sunlight and do not place
near a heat source (e.g. radiator, cooker).
If required, use an insulating plate.
– Allow warm food and drinks to cool down before placing
them in the appliance.
– Defrost frozen food by placing it in the refrigerator.
The low temperature of the frozen food will refrigerate
the food in the refrigerator compartment.
– Open the appliance door as briefly as possible!
21