Cleaning The Appliance; Interior Fittings - Gaggenau RT 222 Mode D'emploi

Cleaning the appliance

m
Caution
▯
Do not use abrasive, chloride or acidic cleaning
agents or solvents.
▯
Do not use scouring or abrasive sponges.
The metallic surfaces could corrode.
▯
Never clean the shelves or containers
in the dishwasher. The parts may become
deformed!
Proceed as follows:
1. Before cleaning: Switch off the appliance.
2. Pull out the mains plug or switch off the fuse!
3. Take out the food and store in a cool location.
Place ice pack (if available) on the food.
4. Wait until the layer of frost has thawed.
5. Clean the appliance with a soft cloth, lukewarm
water and a little pH neutral washing-up liquid.
The rinsing water must not run into the light
or through the drainage hole into the evaporation
area.
6. Wipe the door seal with clear water only and then
wipe dry thoroughly.
7. After cleaning reconnect and switch
the appliance back on.
8. Put the food back into the appliance.

Interior fittings

All variable parts of the appliance can be taken out for
cleaning.
Take out glass shelves
To do this, pull out shelf, lift at the front and take out.
34
Taking out the extendable glass shelf
Hold down levers on the underside on both sides, pull
glass shelf forwards, lift and swivel out to the side.
Condensation channel
To clean the condensation channel, take out the pull-
out container.
Regularly clean the condensation channel
and drainage hole with a cotton bud or similar
implement to ensure that the condensation can drain.