Parkside PPB 10000 A1 Instructions D'utilisation Et Consignes De Sécurité page 45

˜ Switching On/OFF the LED lights
You can light on/off the two LED lights in the powerbank.
*
Press and hold button
*
LED lights; if you press and hold again for 2 seconds,
then the LED lights will switch off.
˜ Troubleshooting
= Problem
= Cause
= Solution
The power bank
It may be that the power bank is not connected properly.
Check that it is connected.
In order to charge the power bank, use a power
supply with an output voltage and current matching the
rated input voltage and current as stated in „Technical
specifications" of this user manual.
A connected device is not being charged.
The battery is drained.
Charge the battery.
The device is not connected.
The device is not connected. Check that it is connected.
Briefly press the ON / OFF button
charging process.
The current consumption of the connected device might
be too low.
42 GB/IE
for 2 seconds to switch on the
4 ] [
is not being charged.
7 ] [
to begin the
4 ] [