Parkside PPB 10000 A1 Instructions D'utilisation Et Consignes De Sécurité page 44

In case if the charging process does not begin
*
immediately, press the ON / OFF button
begin the charging process. The current battery status
of the power bank
process by the LED indicator for battery capacity
To end the charging process, disconnect the USB
*
charging cable from the mobile device and the power
bank . The power bank will switch OFF after approx.
[ 7 ]
30 seconds.
Or simply double click with ON / OFF button
*
The power bank and the LED indicator for battery
capacity
Once charging is complete, remove USB type C plug of
*
the charging cable and closed the protective cover
the device is splash-proof again.
NOTE:
1. If you use all the USB ports, a voltage of 5 V will output
at the outputs. The maximum output current must not
exceed 3.0 A for all outputs.
If the product is not used for a long time, the built-in
*
battery should be fully charged to prolong its operating
life. Regularly charge the built-in battery if you do not use
the product for a long period of time. This is necessary to
preserve the battery.
7 ] [
will switch off.
8 ] [
is displayed during the charging
briefly to
4 ] [
.
8 ] [
.
4 ] [
3 ] [
GB/IE 41
so