Publicité
Les langues disponibles
Les langues disponibles
It must be operated in a dry and well
„
ventilated working environment.
• Connecting compressed air
PLEASE NOTE!
fThis device is designed for operating
pressure (output pressure at the com-
pressor) of up to 6.3 bar. Please bear in
mind that the pressure can lower while
setting the air pressure. Thus, in a hose
length measuring 10 m and an internal
diameter of 9 mm it drops by approx.
0.6 bar.
The compressed air source must have a filter
and regulator.
Connect the compressed air hose
„
the back of the plasma cutter
compressed air connection
insert the side of the compressed air hose
16
into the compressed air connection
of the plasma cutter
connector (see Fig. I).
The pressure can be set via the knob
„
on the condensate separator (see
Fig. I-L). Select a pressure of 4–4.5 bar.
In order to release the compressed air
„
hose
16
, you must press the locking
mechanism of the compressed air connec-
tion
20
and pull out the compressed air
hose
16
at the same time (see Fig. I).
• Connecting the cutting torch
Insert the plasma burner plug
„
plasma burner connection socket
and tighten the union nut hand-tight
(see Fig. A+B).
16
on
1
to the
20
. To do so,
20
1
without a quick
21
7
into the
12
Insert the plasma burner power plug
„
into the plasma burner power socket
and tighten the union nut hand-tight
(see Fig. A+B).
• Connecting the ground cable
Connect the ground terminal plug
the ground terminal - connection socket
Make sure that the connecting shaft is first
connected and then turned. The connecting
shaft must face upwards when plugging in
the ground cable plug
the connecting shaft must be rotated in a
clockwise direction until it reaches the stop,
in order to lock it in place (see Fig. A+B).
This does not require force!
• Fitting the removable roller
guide (optional)
Push the removable roller guide
nozzle clamping sleeve
screws
are completely above the black
23a
area of the plasma burner
gap at the back of the nozzle clamping
sleeve
8b
) (see Fig. A+B). Now fix the
locking screws
. The guide rollers
23a
now positioned such that the required
distance between the workpiece and burner
sleeve
8c
is set. The roller guide is then fixed
in place
23
by tightening the fixing screws
(see Fig. N). Make sure that both guide
23b
rollers
are always set to the same height,
23c
in order to enable straight cutting. You can
see a correctly fitted roller guide in Fig. N.
Before use
6
10
5
with
11
.
5
. After plugging in,
23
over the
8b
, until the locking
8
(behind the
are
23c
GB/IE
41
Publicité
