Parkside PAAP 12 B2 Traduction Des Instructions D'origine page 24

GB IE
5) CAREFUL HANDLING AND USE
OF BATTERY DEVICES
a) Charge the batteries only in
chargers that are recommended
by the manufacturer. Risk of fire if a
charger that is suitable for a specific type
of battery is used with other batteries.
b) In the power tools, use only the
batteries designed for the pur-
pose. The use of other batteries may
result in injuries and risk of fire.
c) Keep the unused battery away
from paper clips, coins, keys,
nails, screws and other small
metal objects, which could cause
bridging of the contacts. A short
circuit between the battery contacts
may cause burns or fire.
d) If used incorrectly, liquid may
leak from the battery. Avoid
contact with this. In the event of
accidental contact, rinse off with
water. If the liquid gets into eyes, seek
medical assistance. Leaking battery fluid
may cause skin irritations or burns.
6) SERVICE
a) Have your power tool serviced
by a qualified repair person us-
ing only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.
Joint safety instructions
for sandpaper sanding
and polishing
a) This power tool is to be used as
a sandpaper sander and polish-
er. Follow all safety instructions,
directives, illustrations and facts
which you receive with the de-
24
vice. If you do not observe the follow-
ing instructions, an electrical shock, fire
and/or serious injury may occur.
b) This power tool is not suitable
for sharpening, wire brushing
and cutting grinding. Using the
power tool in ways for which it is not in-
tended may cause hazards and injuries.
c) Do not use any accessories that
are not specifically intended and
recommended for this power
tool by the manufacturer. Being
able to attach accessories to the device
does not guarantee safe operation.
d) The permissible rotation speed
of the attachment tool must be
at least as high as the highest
rotation speed indicated on the
power tool. Accessories that run
faster than the allowable speed can
break and fly apart.
e) The outside diameter and thick-
ness of the attachment tool must
correspond to the dimensions
indicated for your power tool.
Attachment tools which are wrongly
dimensioned cannot be sufficiently
shielded or controlled.
f) Attachment tools with threaded
attachment must fit the thread-
ing of the grinding spindle
exactly. For attachment tools
which are mounted through a
flange, the diameter of the hole
in the attachment tool must fit
the mounting diameter of the
flange. Attachment tools which cannot
be precisely attached to the power tool
turn unevenly, vibrate very strongly and
can ultimately lead to a loss of control.
g) Do not use any damaged at-
tachment tools. Check attach-
ment tools such as grinding
discs for chipping or cracks,