Pulsar HELION XQ19F Instructions D'utilisation page 6

5
DESCRIPTION OF CONTROLS
BUTTON OPERATING MODE FIRST SHORT
PRESS
ON (11) Device is off Power device on Calibrate the sensor
Display OFF Turn display on Calibrate the sensor
mode
Device is on Calibrate the sensor
UP (10) Regular
Operating modes
(viewing)
Main menu Navigation upwards/rightwards
Quick menu Changes parameters
MENU
Regular
Enter quick menu
(9)
(viewing)
M
Main menu
Confirm selection
Quick menu
Switch between quick menu options
Regular
DOWN
Control
(viewing)
(8)
Main menu
Navigation downwards/leftwards
Quick menu
Changes parameters
REC Video mode Start video
(7) recording
Photo mode
Take a photograph
6
USING THE BATTERY PACK
HELION thermal imaging scopes are supplied with a rechargeable
Li-Ion Battery Pack IPS7 which allows operation for up to 8 hours.
Please remember to charge the Battery Pack before first use.
5
OTHER SHORT LONG PRESS
PRESSES
Turn display off/
Power device off
Color palettes
---- Enter main menu
Exit submenu without
confirming selection /
Exit menu
(switch to
viewing mode)
step-up digital zoom
PiP on/off
Pause / resume Stop video recording /
video recording Switch to photo mode
Switch to video mode
Charging:
Lift the lever (C) of the charging base.
Remove the protective cover from the Battery Pack.
Install the Battery Pack into the charging base as shown in Pic.3;
click the lever (C).
Upon installation, a green LED indicator (D) on the charging base
will start to glow and begin flashing:
- once if the battery charge ranges from 0% to 50%;
- twice if the battery charge ranges from 51% to 75%;
- three times if the battery charge ranges from 76% to 100%;
If the indicator lights green continuously, the battery is fully charged.
You can remove the battery from the charger by lifting the lever (C).
If the indicator of the charger lights red continuously upon battery
installation, probably the battery's charge level is lower than
acceptable (the battery has been long in deep discharge). Keep the
----
battery in the charger for a long time (up to several hours), remove
and re-insert it. If the indicator starts blinking green, the battery is
----
good; if it keeps lighting red it's defective. Do not use the battery!
Connect the Micro-USB plug of the USB cable to the port (E) of the
charger.
Connect the Micro-USB plug to the charger.
Insert the plug of the charger to the 220V socket.
----
Charging
base
----
Battery Pack
C
D
E
Charger
220V socket
Pic. 3
6