Télécharger Imprimer la page

Pulsar HELION XQ19F Instructions D'utilisation page 16

Lunette d'imagerie thermique

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
Problem
Check
The image is blurry,
Calibration is required.
with vertical stripes
and uneven
background.
The image is too
Brightness or contrast level
is too low.
dark.
Poor image quality /
Problems described may arise in adverse weather conditions
Detection range
(snow, rain, fog etc.).
reduced.
Smartphone or tablet
Password in the unit was
PC cannot be
changed.
connected to the
device.
The unit is beyond reliable
No Wi-Fi signal or
erratic signal.
Wi-Fi range.
There are obstacles between
the device and the signal
receiver (i.e. concrete walls).
There are too many Wi-Fi
networks in the area where the
scope is located which may
cause signal interference.
Smartphone or tablet
Password in the unit was
PC cannot be
changed.
connected to the
device.
The device cannot
Remote control is not
be powered on
activated.
with wireless remote
Low battery.
control.
Color stripes appear
The device has accumulated
on the display or
static charge during
images disappears.
operation.
When using the
Because of variations in thermal conductivity, objects (surrounding
scope at below zero
environment, background) under observation become warm more
temperatures the
quickly at above-zero temperatures, which allows higher
image quality is
temperature contrast and, thus, the quality of the image produced
worse than at
by a thermal imager will be better.
At low operating temperatures, objects under observation
positive
(background) normally cool down to roughly identical
temperatures.
temperatures, which leads to lower temperature contrast, and to
image quality (precision) degradation. This is normal for thermal
imaging device.
The term of possible repair of the device is five years.
25
Corrective action
Carry out calibration according
to Section
"SENSOR CALIBRATION".
Adjust brightness/contrast with
the UP/DOWN buttons.
Delete network and connect
again inserting the password
saved in the device.
Place the device in line-of-sight
of the Wi-Fi signal.
To ensure stable Wi-Fi
performance, move the
riflescope to an area with few
or no Wi-Fi networks.
Delete network and connect
again inserting the password
saved in the device.
Activate the remote control
according to instructions.
Install a new CR2032 battery.
As soon as the impact of the
static charge is over, the device
may reboot automatically;
alternatively please turn off and
restart the device.
26

Publicité

loading