Publicité
Les langues disponibles
Les langues disponibles
1. To switch on, press the "I" On switch
and the device starts up (see
2. To switch off, press the "0" off switch
and the device switches off (see
After switching on the device, wait until the
device has reached its max. speed. Only
then must you start with the grinding.
The disk will continue to
run after the equipment is
switched off. There is a risk
of injury.
Test run:
Before starting work and after each
change of grinding disk, carry out a test
run of at least 60 seconds with no load.
Switch off the equipment immediately if the
disk runs lumpy, substantial vibrations oc-
cur, or abnormal noises are generated.
Sharpening drills
Drills with a diameter of 3-10 mm can be
sharpened.
1. Mount the selected sharpener (see
Mounting sharpener).
2. Remove the drill holder (14) from the
sharpener.
3. Insert the drill into the drill holder (14).
Do not attach the drill.
4. Insert the drill holder (14) upwards
into the adjusting device (15) using the
knurled nut for drill-fastening (12).
5. Push the drill to the front into the V-nut
up to the metal stop. The cutting edges
of the drill must fit closely to the metal
surfaces.
6. Using the knurled nut fasten the drill for
3).
drill-fastening (12).
7. Remove the drill holder (14) and insert
3).
this into the rotatable drill mount (11)
from below using the knurled nut for
drill-fastening (12).
8. Check the alignment of the drill. The
cutting edges of the drill must be touch-
ing the grinding wheel (10).
9. Switch the device on and grind the drill
by moving the rotatable drill mount
(11) to and fro in the direction of the
arrow.
10. Switch the device off and wait for the
grinding wheel (10) to stop.
11. Remove the drill holder (14) and insert
it into the rotatable drill mount (11) by
rotating in by 180°. Using the same
adjustment, you can grind the opposite
cutting edge of the drill.
12. Switch the device off and grind the
drill.
13. Switch the device off and wait for the
grinding wheel (10) to stop.
Sharpening picks and
chisels
1. Mount the selected sharpener (see
Mounting sharpener).
2. Place the blade on the tool table (6) so
that it lies against the spacer (4). The
magnetic holder (5) keeps the blade in
position.
3. Release the retaining screw for the an-
gular adjustment (7) and turn the tool
table (6) into position. Select the angle
according to the existing bevel angle
(angle of the bevelled edge).
4. Tighten the retaining screw for angular
adjustment (7) again.
GB
IE
27
Publicité
