Publicité
Les langues disponibles
Les langues disponibles
User manual
- Storage
container is
overfilled with ice
cubes
- Tub tilts fully, ice
cubes are
discharged, but
trough no longer
returns into
original position
Tub tilts fully
(contact with limit
switch is made)
but immediately
returns to original
position
Ice cube maker
not working
despite
production
switched on
User-manual-TopLine-v.02
Storage container
thermostat does not
switch off
1. Defrosting
thermostat does not
transfer voltage to
tilting motor
2. Tilting motor faulty
Mechanical or
electrical fault at hot
gas valve
1. Machine receives
no voltage from
power supply
2. Storage container
is full (storage
container thermostat
has switched off)
3. Storage container
thermostat switches
off before storage
container is full.
4. Ambient
temperature too low
5. Production switch
of the ice cube
maker is faulty
6. Production switch
in wrong position
"Service" or
"Produktion aus/off".
Deutsch 4-43 – English 44-79 – Français 80-114
Readjust storage container
thermostat, replace if
necessary
1. Readjust defrosting
thermostat (set to +17°C) or
replace
2. Replace tilting motor 2
defrosting thermostat
Replace hot gas valve
1. Check socket
2. The ice cube maker will
automatically continue
producing ice once a sufficient
quantity of ice has been
removed from the storage
container.
3. Readjust storage container
thermostat, or replace if
necessary
4.Increase ambient
temperature, or relocated
device if necessary
5. Replace production switch
6. Set production switch to
position "Produktion ein/on".
tilting motor
01/2021
75
Publicité
