Publicité
Les langues disponibles
Les langues disponibles
User manual
Attach the cooling water hose (DN 10) to the cooling water
connection (1) of the machine and route it to the sewage network.
A free outlet according to DIN EN 1717 section 9 must be
established, regardless of whether the siphon connection is higher
or lower than the connection to the machine. Ideally, the siphon
with inlet funnel (on site) is prepared as a floor drain (see Fig.
5.4.c).
Insert the power plug (2) into the socket.
Important installation information for water-cooled models:
This device has DVGW approval!
To avoid contamination of the drinking water due to backflow, the cooling water hose with free outlet
according to DIN EN 1717, Section 9 must be connected to the drainage line.
DIN EN 1717, Section 9: Free discharge over a drainage object
The free outlet over a drainage object must be completely
separated or through ventilation openings.
Failure to comply with the requirements described in Section 9 will invalidate the DVGW approval!
User-manual-TopLine-v.02
Deutsch 4-43 – English 44-79 – Français 80-114
Cooling water hose
(DN 10)
Free spout:
larger than ø siphon,
at least 20 mm
Fig. 5.4.c: Installation instructions for free discharge
over a drainage object according to DIN 1717 section
9 of the cooling water.
01/2021
61
Publicité
