Publicité
Les langues disponibles
Les langues disponibles
User manual
7.2.2 Cleaning the storage container:
(Also see service video capitel 10. or QR code)
If chapter 7.2.1 has already been carried out, continue with point 3.
Start up the ice cube maker by switching on the production switch (Position "Produktion
1.
ein/on").
2.
Switch off the machine at the production
switch (Position "Produktion aus/off").
3.
Remove any ice remaining in the storage
container. Ice intended for consumption must
not come into contact with the detergent!
4.
Remove the metal plate inserts for
draining the condensation water from the
storage container.
5.
Thoroughly spray the storage container
and the metal plate inserts with WESSAMAT
special cleaner and allow a few minutes for the
cleaner to act.
6.
Rinse the storage container and the metal
plate inserts with clear water in order to remove
the special cleaner and dissolved deposits.
Neutralise the remaining special cleaner residues with soap water. A sponge or cloth may be
used for this purpose.
7.
Plug in the socket
8.
Place the metal plate inserts into the storage container.
IMPORTANT:
Almost all cleaners contain acids which can cause corrosion. Therefore, all stainless
steel parts that have been treated with cleaner must be rinsed thoroughly.
!
CAUTION
The first two to three ice drops should be removed from the storage container after
cleaning. There is a risk that this ice may contain residues of cleaning agents and
therefore it is not suitable for consumption.
User-manual-TopLine-v.02
Deutsch 4-43 – English 44-79 – Français 80-114
Fig. 7.1.2: Storage container display with
insert sheets
01/2021
70
Publicité
