Introduction - Mettler Toledo AE Série Mode D'emploi

INTRODUCTION

Additional information / technical data
Balance operation: consult the particular balance Operating Instructions
Connection and configuration of the data output: all necessary information can be found in the Installation Instructions for the
012 Option (included in the option).
METTLER TOLEDO CL data interface: for a general understanding of the CL Data Interface (technical instrument and programming
data), we call your attention to the Technical Information Bulletin (TIB) entitled, "The METTLER TOLEDO CL Data lnterface".
2
General remarks
METTLER TOLEDO AE balances can be equipped with a bidirectional
012 Data Output Option.
AE balances can transfer weighing results to a data receiver
(computer, terminal, etc.) via the two data interfaces (20 mA current
CL
loop and RS232C). At the same time, however, they can also
RS232C
receive and carry out instructions (full duplex operation). This makes
it possible for AE balances to be integrated into controlled weighing
systems.
The following can be connected to the current loop data interface:
– a METTLER TOLEDO CL instrument
– a METTLER TOLEDO printer (only with option 011)
– a non-METTLER TOLEDO instrument (computer, terminal,
A correspondingly equipped non-METTLER TOLEDO instrument
(terminal, computer, printer, etc.) can be connected to the
RS232C data interface.
printer).