Test Button - HumanTechnik lisa Mode D'emploi

4. Function test by pressing the test button
Signal

Test button

Flashes
once
Flashes
once
Flashes
once
Flashes
once
5. For a detailed status display, the Genius Home and Genius Pro smartpho-
ne apps can be used. Transmission to the app is started by pressing the
test button for at least 3 seconds.
6. The results are to be noted and, if necessary, to be corrected by main-
tenance service.
1) According to norm DIN EN 14604, the acoustic signalling is sufficient.
2) Note: The smartphone apps Genius Home and Genius Pro can interpret and display the
condition of the according smoke detector.
Note:
The function test is to be carried out by the test button only. Due to inter-
nal alarm filters, this detector is not suitable for alarm triggering by test
aerosols.
52
Horn
1)
Positive self-test tone
once simult. with LED
Negative self-test tone
once simult. with LED
Negative self-test tone
once simult. with LED
Negative self-test tone
once simult. with LED
Condition
Feedback function test
positive
Contamination forecast below
15 months
Feedback of function test „End of
life", replace device
Feedback of function test „Failure
detected", replace device
2)
2)