Installation Of The Smoke Detector - HumanTechnik lisa Mode D'emploi

7. Installation of the smoke detector

Humantechnik recommends an installation with screws and wall plugs in
order to ensure a safe and permanent connection.
Installation with screws and wall plugs:
Use the supplied fixing material for installation of the smoke detector. If
other screws are used, these must not project into the base more than
5 mm.
We recommend the use of a fillister head screw DIN ISO 7049, cross
recess H, form C, 3.5 x 25 mm. The mounting surface must be even!
Fastening by means of a Humantechnik adhesive pad:
Only the original adhesive pad should be used for installation by means
of an adhesive pad. This has to be ordered separately (see item 17
Ordering data).
Surfaces on which the adhesive pad is to be mounted have to be smooth,
even, undamaged, clean and free of dust, grease and solvents. The ad-
hesive pad must not be used on porous surfaces, e.g. plaster, emulsion
paint, plywood, chipboards and hardboards, chalky or loose paintings,
crumbling plaster or dirty surfaces.
Adhesive pads may leave residues after disassembly!
The use of the adhesive pad is always at the user's own risk.
When using the adhesive pad, please pay attention to its
mounting instructions.
44