Hoonved ELDING NORDIC TLC100 Mode D'emploi page 21

Part 2: Reserved for the operator
2.4 DESCALING
In the presence of hard water, limestone deposits form
inside the machine and on the dishes which, for hygienic
and operational purposes, must be removed by descaling.
The procedures and their frequency are usually recom-
mended by the supplier of the descaler, who has appropriate
products.
To avoid damaging the machine, do not overdo it with the
doses, and strictly abide by the instructions of the descaler
manufacturer. When the operations are completed, rinse
with plenty of water.
2.5 TEMPORARY
In case of a prolonged stop of a few weeks, before closing
the machine, it is recommended to fill the tank with clean
water and to perform a few empty cycles. Then drain the
water so that bad smells are not produced and the pump
does not remain dirty.
If necessary, repeat this operation several times until the
water is clean after the empty wash cycle.
If the downtime is too long, it is recommended to oil the
stainless steel surfaces with vaseline and to drain the water
from the boiler and the electric pump.
2.6 DEMOLITION and
DISPOSAL
When you intend to scrap the machine, drain the water from
the tank and the boiler, as indicated in the previous points,
and disconnect the machine from the water and electric
mains. Then dismantle the components following that pre-
scribed in the relevant standards in force in compliance with
the national and local ecological-environmental regulations,
taking care to separate the parts as follows:
- metal parts: body, surfaces, panels, filters;
- electric parts: motors, contactors, microswitches,
wires;
- plastic parts: fittings, dish racks;
- rubber parts: hoses, sleeves.
DOWN TIME
2.7 SCHEDULED
and PREVENTIVE
MAINTENANCE
It is recommended to service the machine accord-
ing to the scheduled maintenance at least every 6
MONTHS, by contacting the authorised technical
assistance service.
The manufacturer will not be held liable for any
printing errors in this booklet.
The instructions, drawings, tables and all else
contained in this booklet are of a confidential
technical nature and therefore, the information
cannot be reproduced, either in whole or in part,
or disclosed to third parties without the written
consent of the manufacturer who has exclusive
ownership thereof and reserves the right to make
any changes deemed appropriate without prior
notice.
ENGLISH
21