Hoonved ELDING NORDIC TLC100 Mode D'emploi page 15

Part 1: Use and safety instructions
1.1 GENERAL DESCRIPTION
Single skin body, stainless steel execution AISI 304.
Single piece deep drawn tank with multiple filtering
system (pump suction, collection filter and micro-filter)
with presence indicator. Upper and lower stainless steel
wash and rinse arms. Self draining wash pump. Hood
activated cycle start and manual cycle start. removable
rack holder. Self-cleaning cycle at unit switch-off. Up-
per control panel. Self draining wash pump. Built in HR
drain pump. Electronic adjustment of the detergent and
rinse aid dispenser.
1.2 TYPE OF USE AND
CONTRAINDICATIONS FOR USE
The machines were designed and built to wash dishes
in specific dish racks, using detergent and rinse aid.
• Objects allowed: glasses, mugs, cups, saucers, cut-
lery, inserted in specific dish racks, made of suitable
material for dishwashers and sized for the dish rack
and machine.
• All specific detergents and rinse aid for industrial
dishwashers normally found on the market may be
used.
ATTENTION
Any
improper use of the machine relieves the manufac-
turer from all liability for accidents to property or persons
and terminates any warranty conditions.
1.3 TRANSPORT, SHIPPING AND
STORAGE. (Fig. 2)
- The machine is normally shipped inside a cardboard
box secured with straps.
- Use a forklift truck or pallet truck to transport the
packed machine, placing the box on the relative forks.
ATTENTION
The machine must only be shipped and stored sheltered
against atmospheric agents.
1.4 CONTROLS UPON RECEPTION
When the supply is received, check that the packages
are intact and visually not damaged.
If all is intact, remove the packaging (unless different
instructions are given by the manufacturer) and check
that the machine has not been damaged during trans-
portation.
Check for any structural damage, crushing or breakage.
If any damage or imperfections are found:
1- Immediately notify the carrier either by telephone
or through registered mail with acknowledgment of
receipt;
2- Inform the manufacturer through registered mail with
acknowledgment of receipt.
IMPORTANT
A
ny damage or faults must always be promptly reported
within 3 days from the data of receipt of the machine.
1.5 UNPACKING (Fig. 2-3)
Proceed as follows to remove the machine from the
packaging:
1. Remove the straps (1) securing the box.
2. Remove the box (2), lifting it upwards.
3. Remove the protective film from the machine.
4. Remove the machine from the base, lifting it from the
bottom of the body.
5. All packaging elements must be collected and not
left within the reach of children as they are sources
of danger. They must be disposed of as solid urban
waste.
ATTENTION
O
nce the machine is unpacked, NEVER lift it by the
electric components box.
Lift the machine from the bottom of the body. Place it on
the forks of the forklift truck to transport it.
1.6 MACHINE
IDENTIFICATION (Fig. 4)
- The serial number and relative machine data are
written on the rating plate (3) on the right side of the
machine.
IMPORTANT
To request technical support or to order spare parts, al-
ways include the model and serial number of the machine.
1.7 DESCRIPTION OF THE SAFETY
DEVICES
• The TLC models are equipped with a safety micro-
switch which blocks the wash pump when the tank
door is accidentally opened.
• Electric parts closed by panels secured with screws.
• Electric equipotential earth electrode.
• Safety overflow (16) Fig.8 to prevent water from
overflowing.
1.8 REGULATORY REFERENCES
•
The machine and its safety devices are built in
compliance with the following standards:
•
Essential safety requirements set forth by directives
2006/42/EC (MD), 2014/30/EU (EMC).
• Requirements set forth by directive 2011/65/EU
(RoHS 2).
ENGLISH
15