Create Wind Curve Manuel D'instructions page 14

DECOR ATIV E COVE R AS SE MB LY
* Only for the model WITHOUT LIGHT
• Once the connections plate has been assembled and secured, screw the decorative
cover back to the connections plate using the central screw.
LIGH T AS SE MB LY
* Only for the model WITH LIGHT
• Connect the single pin sockets on the breakout board to those on the LED panel. The LED
panel is magnetized so it attaches to the connection board by simply putting both pieces
together.
Note: While installing or removing the LED board, be careful not to touch the insulating tabs.
Do not overtighten the screws or thread them too quickly as this could cause damage to the
insulating tabs.
• Finally, place the decorative light shade by screwing it onto the LED plate.
E NGL I SH
14