Create Wind Curve Manuel D'instructions page 10

IN STAL L ATION P RE PAR AT IO N
• To avoid personal injury and injury, ensure that the fan is hung in a location that allows
the blades to be 2.3 m or more from the floor and 76 cm from the nearest wall or obstacle.
• Make sure the mounting bracket is properly attached to the building structure and can
support the full weight of the fan.
INSTALLI N G THE MOU NT I NG B R ACKE T
• Check that the ceiling where you intend to mount the fan is stable and capable of safely
supporting the weight of the fan.
• Do not fix the mounting bracket directly on ceilings less than 10mm to avoid the risk of the
screw loosening and coming out.
Wood roof
Drill the necessary holes and then secure
the mounting bracket with the wood
screws and washers to the ceiling joints.
NOTE: This fan can also be installed in a false ceiling, for this you must use fixing screws
with a spring lever (not included).
• Mark the correct position of the holes and fix the ceiling support using the screws with
metal anchors or screws and washers suitable for the type of ceiling chosen.
• Verify proper installation of the bracket before hanging the fan. The mounting bracket
must support the entire weight of the fan.
E NGL I SH
10
INSTALLATION INSTRUCTIONS
76 cm
2.3 m
Concrete roof
Drill holes with an 8mm drill bit, accord-
ing to the length of the expansion screws.
Next, secure the mounting bracket to the
ceiling with the expansion screws.
76 cm