Create Wind Curve Manuel D'instructions page 11

C HOICE OF MOUNT I NG T YPE
Traditional assembly
The traditional setup hangs from the ceiling
with a rod.
This fan can be installed on both a regular and vaulted ceiling, and can extend the hanging
length with the longer hanging rod (supplied). To install the hanger bar you will need the
following tools: a screwdriver, flat head screwdriver, adjustable pliers or wrench, step ladder,
wire cutters, and electrical tape.
S USPE N SI ON BAR INSTALL AT I ON
• If you want to extend the hanging length of your fan, remove the ball from the hanger rod
and use the additional extension rod (included).
• If you want to use the extension bar, follow the following instructions:.
1. To remove the ball from the suspension rod, loosen the set screw and remove the
cotter pins.
2. Lower the ball and remove the locking pin.
Angle mounting is recommended on sloped
or vaulted ceilings.
Barrette
lock
Angle mounting
Cabling
Floron
Extension
bar
Trim
Cap screw
Throne of
fixation
E NGLI SH
11