Create Wind Curve Manuel D'instructions page 12

3. Take the ball out of the hanger bar and insert it into the longer hanger bar (the top of the
bar has a hole for the set screw; use this to secure the bar).
4. Insert the locking pin into the end of the suspension rod and raise the ball. Make sure the
locking pin is aligned with the grooves inside the ball and secure the set screw.
Advice: To make it easier to insert the wires into the bar, place some electrical tape around
the wires. This will help you keep them together as you insert them into the bar.
5. Loosen the mounting screws and washer from the top of the motor housing. Remove the
bar pins (if you haven't already). Insert the rosette through the bar.
6. Thread the cables through the bar and pull the excess cables from the top of the bar to
tighten them.
7. Place the bar inside the motor housing and insert the pins you removed earlier. Tighten
the set screws and washers.
8. Lower the canopy towards the motor housing.
W IRING CON N ECTI ON
Make the connection between the receiver wires and the fan motor wires following the color
indications. Make sure the connection is tight.
Take ground
L
N
DR IV E R CONN ECT I ON AND CE ILI NG ROSE AS SE M B LY
Make the connection between the receiver wires and the fan motor wires following the color
indications. Make sure the connection is tight.
E NGL I SH
12
L input (black)
Remote
control
receiver
Input N
(white)
Ground (green/yellow)
DC L motor (gray)
DC L motor (pink)
DC L motor (red)