Publicité
Les langues disponibles
Les langues disponibles
NOTICE
The Swing Maxi
Hands-free breast pump has a closed
™
system so milk cannot get into the tube when the pump is
used as instructed. Do not clean or rinse the tubing
under any circumstance.
• Inspect the tubing before use. If you find
condensation, breast milk or mould in the tubing,
discontinue use and replace tubing.
Refer to chapter 13 for ordering information.
• Do not run the breast pump with wet tubing; doing so
will cause damage to your breast pump.
6.2 Washing
Refer to figure ¢4 on the foldout pages.
Rinse and wash by hand
(before first use and after each use)
Do not place the parts directly in the kitchen sink for rinsing and
washing. Use a dedicated wash basin for infant items.
1. Rinse the disassembled parts, except for the tubing, with cold,
clear drinking quality water (approx. 20 °C).
2. Clean these parts with plenty of warm, soapy water (approx.
30 °C / 86 °F). Use a commercially available dish soap and clean
soft brush.
3. Rinse the parts with cold, clear drinking
quality water for 10 to 15 seconds
(approx. 20 °C / 68 °F).
4. Drying: Allow to air dry on a clean,
unused dish towel or paper towel.
Information
By using the dishwasher, parts may become discolored. This will not impact the functioning of the parts. Never wash the tubing. See chapter 6.1 for more details.
or
4. Dry
Air-dry
Allow to air-dry on a clean, unused dish
towel or paper towel. Store the dry parts
in a clean environment.
Do not store parts in an airtight
container/bag if moist. It is important that
all residual moisture dries.
• Take care not to damage parts of the collection cups during cleaning.
• Store the dry collection cups in a clean bag/container until next use.
• Do not store wet or damp parts as mould may develop.
• If you notice a white residue on your collection cup parts after
boiling, your water may have a high mineral content. Remove
residue by wiping parts with a clean towel and allow to air dry.
• Distilled water is recommended when boiling parts to prevent
substantial mineral build-up over time, which may compromise
your parts.
Wash in dishwasher
(maximum once per day)
1. Dishwashing: Place the disassembled parts, except for the tubing,
on the top rack or in the cutlery section. Use a commercially
available dishwashing detergent.
2. Rinse the yellow membrane under running water after dishwashing.
3. Drying: Allow to air dry on a clean, unused dish towel or paper towel.
4. Dry
7
Allow to air-dry on a clean, unused dish
towel or paper towel. Store the dry parts
in a clean environment.
Do not store parts in an airtight
container/bag if moist. It is important that
all residual moisture dries.
Air-dry
9
7
Publicité
