Publicité
Les langues disponibles
Les langues disponibles
GB
MT
Residual risks
There will always be residual risks even
if you operate this power tool according
to the instructions. The following hazards
may occur in connection with the type and
design of this power tool:
• Hearing damage if suitable ear protec-
tion is not worn.
• Health injuries resulting from the effect
of vibration on the hands and arms in
the event that the device is used over
a longer period of time or is not used
and maintained properly.
• Cutting injuries
WARNING! Danger due to electro-
magnetic field generated while the ma-
chine is in operation. Under certain cir-
cumstances, this field may negatively af-
fect active or passive medical implants.
In order to reduce the danger of serious
or fatal injuries, we recommend that indi-
viduals who wear medical implants should
consult their doctor and the manufacturer
of the implant before operating the ma-
chine.
Preparation
WARNING! Risk of injury due to
unintentional start-up. Only insert the re-
chargeable battery into the device once
the device is fully prepared for use.
Control elements
Familiarise yourself with the operating ele-
ments before using the device for the first
time.
• Direction of rotation switch (7)
NOTICE! Only operate the direction
of rotation switch when the tool has
stopped!
The arrow on the direction switch (7) in-
dicates the working direction.
•
Screw in screw, drill
26
• Centre Switch lock
•
Unscrew screw
• Torque adjustment ring (4)
Setting of the maximum torque for
screwing at which the slipping clutch is
disengaged.
NOTICE! Only operate the torque ad-
justment ring when the device is at a
standstill!
• 1 lowest torque
• 19 highest torque
To be safe, start with a low torque
when screwing. Increase torque ac-
cording to requirement.
•
drilling without torque limit
• Gear selector switch (6)
NOTICE! Only operate the gear select-
or switch when the tool has stopped.
• 1
Screws
• 2
Drill bits
• On/Off switch (11)
• Switching on: Press
• Control the speed progressively: The
further you press the on/off switch,
the higher the speed.
• Switching off: Release
Using the bit holder
Notes
• To use the bit holder (15) you must re-
move the keyless chuck (2).
Removing the keyless chuck Fig. B
1. Hold the keyless chuck (2) tightly from
the front. Pull the drill chuck ring (3) in
the direction of the keyless chuck (2).
2. This unlocks the keyless chuck (2) and
it can be removed from the front.
Using the bit holder Fig. C
1. Insert a suitable 6-point bit in the bit
holder (15). Because of the 6-point bit
Publicité
