Parkside PWSAM 20-Li A1 Traduction Des Instructions D'origine page 40

GB MT
ning direction of the disc must match
the direction of rotation arrow (3).
4. Position the clamping flange (16).
The side with the marking on the
clamping flange must be visible.
5. Press and hold the spindle lock (4).
6. Tighten the clamping screw (15) with
the hex key (14). You can release the
spindle lock (4).
Fitting and removing the
attachment on the guard
cover
Fitting the attachment (1) (Fig. B)
1. Remove the battery (9) from the
device.
2. Disassemble the attachment tool.
3. Place the attachment (1) on the guard
cover (18) and turn the attachment (1)
until the attachment audibly clicks into
place.
Removing the attachment (1)
(Fig. B)
1. Remove the battery (9) from the
device.
2. Disassemble the attachment tool.
3. Release one of the two locks (2) on the
attachment (1) by pushing the lock out-
wards.
4. Slide the released lock (2) over the
guard cover (18) until the attachment
is removed after half a turn.
Checking the battery charge
level
1. Press the button (7) next to the charge
level indicator button (8) on the battery
(9).
The LEDs of the charge level indicator
show how much charge remains in the
battery.
40
LEDs
red, orange, green Battery charged
red, orange
red
2. Charge the battery (9) when only the
red LED on the charge level indicator
(8) is illuminated.
Charging the battery
See also the charger instruction manual.
Notes
• If warm, allow the battery to cool be-
fore charging.
• Do not expose the battery to direct sun-
light for long periods and do not place
it on a radiator (max. 50°C).
Charging the battery
1. Remove the battery (9) from the
device.
2. Push the battery (9) into the charging
slot of the battery charger (12).
3. Connect the battery charger (12) to a
power outlet.
4. After charging, disconnect the battery
charger (12) from the mains.
5. Pull the battery (9) out of the battery
charger (12).
Control LEDs on the charger (12):
green red
lights up —
— lights up
— flashes
flashes flashes
Meaning
Battery partially
charged
Battery needs to be
charged
Meaning
• Battery is fully
charged
• stand-by (No
battery inserted)
Battery is charging
Battery is over-
heated
Battery is defective