Publicité
Les langues disponibles
Les langues disponibles
GB
MT
– Borehole .................................⌀ 10 mm
– Thickness ..................................... ≤ 4 mm
thread .................................................... M6
Sound power level (L
..................................... 86.6 dB; K
Sound pressure level (L
...................................... 78.6 dB; K
Vibration (a
) ....... ≤2.5 m/s²; K=1.5 m/s²
h
Battery ................................................. Li-Ion
Temperature ................................... ≤50 °C
– Charging ................................5 – 45 °C
– Operation .............................. 0 – 50 °C
– Storage .................................. 0 – 45 °C
PARKSIDE Performance Smart battery
Smart PAPS 204 A1/Smart PAPS 208 A1
– Frequency ƒ ........2400 – 2483.5 MHz
– transmitted power ................... ≤ 20 dBm
Cutting disc ........................ PTS 76
Disc rotational speed n
Disc speed v
.............................. ≤ 80 m/s
0
diameter ...................................... Ø 76 mm
Borehole .....................................⌀ 10 mm
Thickness ............................................ 1 mm
Levels of noise and vibration were determ-
ined according to the standards and regu-
lations in the declaration of conformity.
The specified total vibration value and the
stated noise emission value have been
measured according to a standardised
test method and can be used to compare
one power tool with another. The specified
total vibration value and the stated spe-
cified noise emission value can also be
used for a provisional assessment of the
load.
WARNING! The vibration and noise
emissions may deviate from the specified
values during actual use of the power tool,
depending on how the power tool is be-
ing used. Try to keep the exposure to vi-
30
)
WA
=3 dB
WA
)
pA
=3 dB
pA
−1
≤ 20100 min
max
brations as low as possible. An example
of a measure to reduce vibration exposure
is limiting the working hours. All parts of
the operating cycle have to be considered
while doing so (for example, times when
the power tool is switched off and times
when it is switched on but running without
any load).
WARNING! Grinding thin metal
sheet or other well vibrating structures
with a large surface area can result in
increased noise exposure and a much
(up to 15 dB) higher overall noise emis-
sion than the specified noise emission val-
ues. Use heavy flexible damping mats or
similar to prevent sound radiation from
such workpieces. Take into account the in-
creased noise emission and wear appro-
priate hearing protection.
Charging time
The device is part of the X 20 V TEAM
series and can be operated with bat-
teries of the X 20 V TEAM series. Bat-
teries of the X 20 V TEAM series may
only be charged using chargers of the
X 20 V TEAM series.
We recommend that you operate
this appliance with the following bat-
teries only: PAP 20 B1, PAP 20 B3,
Smart PAPS 204 A1, Smart PAPS 208 A1
We recommend charging these bat-
teries with the following chargers:
PLG 20 A3, PLG 20 A4, PLG 20 C1,
PLG 20 C3, PLG 201 A1, PDSLG 20 A1,
PDSLG 20 B1, Smart PLGS 2012 A1
Rechargeable battery and charger tech-
nical data: See separate manual.
The charging time is influenced by factors
such as the temperature of the environ-
ment and the battery, as well as the mains
voltage applied, and may therefore devi-
ate from the specified values.
Publicité
