Publicité
Les langues disponibles
Les langues disponibles
5) Support panels or any oversized
workpiece to minimize the risk of
wheel pinching and kickback. Large
workpieces tend to sag under their own
weight . Supports must be placed under the
workpiece near the line of cut and near the
edge of the workpiece on both sides of the
wheel .
6) Use extra caution when making
a "pocket cut" into existing walls
or other blind areas. The protruding
wheel may cut gas or water pipes, electrical
wiring or objects that can cause kickback .
Additional safety instructions for
wire brushing operations – Safety
warnings specific for wire brushing
operations
1) Be aware that wire bristles are
thrown by the brush even during
ordinary operation. Do not
overstress the wires by applying
excessive load to the brush. The
wire bristles can easily penetrate light
clothing and/or skin .
2) If the use of a guard is
recommended for wire brushing,
do not allow any interference
of the wire wheel or brush with
the guard. Wire wheel or brush may
expand in diameter due to work load and
centrifugal forces .
Additional angle grinder warnings
1) Connect the product only to a power socket
with a residual current circuit breaker of
rated residual current no more than 30 mA .
2) Keep power cords and extension cords
away from the disc . If they are damaged or
cut through, immediately pull the plug from
the outlet . Do not touch the cable before
it has been disconnected from the power
supply . Risk of electric shock!
3) If the replacement of the supply cord is
necessary, this has to be done by the
manufacturer or his agent in order to avoid
a safety hazard .
14 GB/IE/NI
4) Only use grinding wheels where the
indicated rotational speed is at least as high
as what has been specified on the name
plate of the product .
5) Carry out a visual inspection of the grinding
wheel before use . Do not use any damaged
or deformed wheels . Replace any damaged
or worn wheels .
6) Make sure that the sparks produced
by grinding do not present a danger,
e .g . reach people or ignite flammable
substances .
7) Always wear safety goggles, safety gloves,
respiratory protection and ear protection
when grinding .
8) Never keep the fingers between the wheel
and spark protection or in close proximity
to the protective hoods . There is a risk of
crushing .
9) The rotating parts of the product cannot
be covered due to functional reasons .
Therefore, proceed cautiously and hold the
workpiece firmly in order to avoid slipping
which could cause your hands to come into
contact with the wheel .
10) The workpiece gets hot during grinding .
Do not touch the machined area, allow it
to cool down . There is a risk of burning . Do
not use coolants or the like .
11) Do not work with the product, if you are
tired or have consumed alcohol or tablets .
Always have a break on time .
12) Switch the product off and remove the
mains plug
to loosen a blocked insertion tool,
–
if the connection line is damaged or
–
entangled,
in case of unusual sounds .
–
If the replacement of the supply cord is
necessary, this has to be done by the
manufacturer or his agent in order to avoid
a safety hazard .
Publicité
