Publicité
Les langues disponibles
Les langues disponibles
˜ Mounting the handle (fig. A)
m
WARNING!
The product must only be operated with
u
the handle
mounted .
1 ]
[
Depending on the method of working,
o
tighten the handle on to the handle thread
on the left
, right (fig . A) or top
7 ]
[
product .
˜ Assemble/set protective
cover/demounting (fig. D)
NOTE
If the protective cover
u
the position illustrated in fig . D j, push
the whole protective cover against the
product and turn it at the same time .
Adjust the protective cover such that any
o
sparks or detached parts cannot hit either
the user or any bystanders .
The protective cover must also be
o
positioned such that the sparks cannot
ignite combustible parts, including those in
the surroundings .
Demounting the grinding disc
1 . Press the spindle lock button
2 . Turn the mounting spindle
spindle lock fixed the mounting spindle .
Keep and continue to hold down the
spindle lock button .
3 . Release the clamping nut
the chuck key
13 ]
[
the spindle lock button .
4 . Take off the clamping nut, the mounting
flange
(fig . B) and cutting disc from the
14 ]
[
mounting spindle .
of the
[
2 ]
is engaged in
9 ]
[
(fig . A) .
10 ]
[
until the
16 ]
[
(fig . B) with
15 ]
[
(fig . A) . You can release
Attaching the protective cover
5 . Put the protective cover
such that the open side is facing back
towards the product .
The teeth on the protective cover and on the
product must mesh together (see fig . D j) .
6 . Push the protective cover towards the
product to turn it (see fig . D k) .
7 . Fasten the wire ring
protective cover by pressing it into the flute
of the product's teeth .
8 . Turn the protective cover into the working
position . The closed side of the protective
cover must always face the operator .
9 . Readjust the position of the protective
cover if you find during use that it does not
provide optimum protection .
Removing the protective cover
10 . Take off the protective cover
removing the wire ring
an object such as a small screwdriver (see
fig . D l) .
For simple removal, turn the protective cover
only after taking off the wire ring to the
position shown in the detail illustration in
fig . D j .
˜ Fitting the attachment to/
removing the attachment
from the protective cover
(fig. E)
Fitting the attachment
1 . Fit the attachment
which the running direction is indicated by
an arrow, onto the protective cover
2 . Push the attachment onto the protective
cover until it clicks into place .
onto the product
[
9 ]
to secure the
23 ]
[
by
9 ]
[
with the help of
23 ]
[
, with the side on
9a ]
[
.
[
9 ]
GB/IE/NI
17
Publicité
