Parkside PWS 125 G6 Instructions D'utilisation Et Consignes De Sécurité page 21

m CAUTION! Risk of injury!
Only use accessory parts where the
u
printed rotational speed is at least as
high as what has been specified on the
name plate of the product .
Do not use any broken, cracked, or
u
otherwise damaged grinding discs .
Never operate the product without
u
protective equipment .
Support the plates or workpieces in order
u
to reduce the risk of kickback from a
jammed cutting disc . Large workpieces
may bend under their own weight . The
workpiece must be supported on both
sides of the disc, not only near the cutting
disc, but also at the edge .
Keep your hands away from the disc
u
when the product is in operation . Risk of
injury .
NOTE
Information on replacement
Never operate the product without
u
protective equipment .
Ensure that the rotation speed stated on
u
the tool is the same or higher than the
nominal idle speed of the product .
Ensure that the tool dimensions match
u
those of the product .
Only use flawless discs (ringing test:
u
when you strike the grinding disc with
a plastic hammer, it results in a clear
sound) .
NOTE
Never re‑drill a locating hole which is too
u
small to make it larger .
Never use separate bushings or adapters
u
in order to make grinding discs with a
hole that is too large fit the product .
Do not use any saw blades .
u
To clamp the grinding tools only use the
u
clamping flange provided . The pads
between the clamping flange and the
grinding tools must be made of elastic
materials e .g ., rubber, soft cardboard etc .
Reassemble the product completely after
u
replacing the tool .
m WARNING!
Switch off the product and remove
the mains plug . Allow the product to
cool down .
m WARNING!
Wear protective gloves when
changing the tool so as to avoid
injuries from cuts .
m WARNING!
The clamping nut
u
screwed too tightly so as to avoid
breaking the disc and nut .
˜ Switching on and off
m WARNING!
Make sure that the mains supply voltage
u
matches the voltage rating indicated on
the product's type plate .
must not be
15 ] [
GB/IE/NI 19