klover AURA 100 Instructions D'utilisation page 44

CS.A80.IST-1 / Rev 1.0
The image below shows the screen for the "SET DUCTED ROOM" menu item:
To modify the room temperature, select the "SET DUCTED ROOM" to be modified ("SET ROOM 1" or "SET ROOM 2") by pressing keys 4 (Set) or 5
(Esc).
Press keys 1 and 2 (Increase and Decrease) to adjust the value; values between 07°C and 40°C can be set.
Press key 3 (On/Off) to exit the menu, saving the set value.
INITIAL CONFIGURATIONS
Connecting the remote control
The first time the product is powered or any time you want to change the connection channel, the remote control must be interfaced with the support
panel fitted on the appliance. This should be carried out as follows:
1. Press keys 3 (On/Off) and 4 (Set) on the remote control for several seconds.
2. The words "MENU' RADIO ID" will appear, along with the channel the remote control is linked to if it has already been configured.
3. Using key 2 (Decrease) on the remote control, choose "NEW", then confirm by pressing key 4 (Set).
4. Using keys 1 or 2 (Increase or Decrease) on the remote control, choose the channel to connect to. Do not confirm by pressing key 4 (Set).
5. Press keys 1 (On/Off) and 2 (Power) on the support panel at the same time, holding them down until all the LEDs are lit.
6. Confirm the channel selected previously by pressing key 4 (Set) on the remote control; the remote control will be begin searching for a channel
to connect to.
7. If the operation has been performed correctly, the user screen for the appliance will appear on the remote control. If this is not the case, it will
display a message saying the channel was not found; repeat the operation in this case.
Connection to the WiFi network
The appliance is equipped with a Wi-Fi board that enables it to be remotely controlled via the "KLOVER HOME" App, which can be downloaded to
smartphones or tablets from various stores (Apple, Android, etc.).
The procedure for connecting the Wi-Fi board to the domestic network is explained below:
1. Power the appliance by touching the "ON/OFF main switch" located on the rear of the appliance itself.
2. Download and install the "KLOVER HOME" App on your device.
3. Access the "KLOVER HOME" App and select "Add Stove", following the guided procedure.
The installation and use instructions of the wifi module integrated into the device are visible by scanning the following QR Code with your smartphone:
https://docs.klover.it/it/guide/help/cs-wifi20-ist
17
SET ROOM ZONE 1
(Room temperature for zone 1,
can be set at values between
07°C and 40°C)
ENGLISH