Mustang Survival MIT 70 Manuel D'utilisation page 8

2. For the MD4042 only: Ensure the bobbin (Fig. 2) is valid by
checking the expiration date on the side of the bobbin.
If the bobbin has expired, re-arm your flotation device (see "Re-
arming" on page 12).
3. Undo the Velcro™ strips along both sides of the flotation device.
4. Ensure the oral-inflation cap is in the stowed position (Fig. 7).
5. Check for damage or excessive abrasion, wear, tear and/or any
visible foreign matter, such as mildew or oil stains. Check that all
seams are secure, and all straps and hardware are sound. If you
see any signs of damage, perform the "Every Six Months" tests,
described in "Care and Maintenance," page 15.
6. Ensure the pull-tab lanyard is hanging on the outside, and secure
the Velcro™ strips on both sides of the flotation device.
103120
EX10/25
FIGURE 2
CONTACT YOUR MUSTANG DEALER IF YOU HAVE ANY CONCERNS
ABOUT THE READINESS OF YOUR FLOTATION DEVICE.
USE AT COLD TEMPERATURES
As temperatures approach freezing, your inflatable flotation device
will provide less buoyancy and will inflate more slowly. At
temperatures near freezing, the device should be worn partially
inflated to ensure that some buoyancy is immediately available to
you if you fall overboard. The oral inflator can then be used to
adequately top up the flotation device after CO
Caution: Do not fully inflate the device orally and then activate the
CO cylinder. The resulting overpressure could seriously damage the
2
device resulting in loss of flotation.
Inflatable flotation devices are not recommended for use in
temperatures below freezing.
5
Manufacture Date (MMDDYY)
Expiration Date (EX MM/YY)
inflation.
2