Mustang Survival MIT 70 Manuel D'utilisation page 14

4.
Rotate the yellow lever back towards the inflator so that it is
flush against the grey body. The yellow lever should not be
extending out from the inflator (see Fig. 9).
Check the new cylinder. Ensure that the CO
5.
been pierced (see Fig. 10).
Install new cylinder (see Fig. 11). Hand-tighten until snug.
6.
WARNING: IF THE LEVER ARM IS NOT FLUSH AGAINST GREY BODY THE CYLINDER MAY
BE PIERCED.
Solid
Cylinder
Top
CHECKING C0
FIGURE 10
INSTALL CYLINDER
FIGURE 11
7. Check to be sure status indicator is GREEN (see Fig. 12).
FIGURE 12
STATUS INDICATOR
8.
Refold the PFD in accordance with the Repacking section (see
"Repacking Your PFD" page 14). Your MD4041 Inflatable PFD
is now ready for manual use.
11
Pierced
Cylinder
Top
CYLINDER
2
lever
OK
cylinder has not
2
Caution:
Do not use if the
cylinder top is pierced.
CYLINDER IS SNUG