Publicité
Les langues disponibles
Les langues disponibles
REARMING (MD4042)
To re-arm your flotation device, you will need Mustang Survival's Re-
Arm Kit MA4041. The spent inflation parts will first be removed, and
replacement parts will be installed. The re-arm kit includes:
17g CO
cylinder
2
Bobbin
WARNING
• Use only with specified PFD/life jacket models.
• The gas (CO
) cylinder is under pressure, therefore misuse can be dangerous.
2
• Avoid prolonged exposure to sunlight, do not store above 120°F (50°C).
• Do not throw into open fire (incinerate) or dump at sea.
• Keep away from children.
• Dispose of CO
• Discharge and dispose of corroded or rusty cylinders.
• Bobbin will dissolve in water.
IMPORTANT: FOLLOW INSTRUCTIONS IN THE EXACT SEQUENCE BELOW.
1.
Unpack or open the deflated PFD/life jacket (see pg. 9) on a flat
surface and expose the inflator (Fig 13).
2.
Remove the empty CO
counterclockwise. Discard cylinder.
3.
Remove grey cap by turning it counterclockwise.
4.
Remove bobbin from cap or housing unit.
NOTE: THE BOBBIN (YELLOW) MAY REMAIN IN THE CAP OR IN THE HOUSING ASSEMBLY
WHEN YOU REMOVE THE CAP.
5. Check the housing to be sure it is clear and dry. If necessary, rinse
the inflator with fresh water to remove dirt and salt. Let dry.
6. Inspect the bobbin. Verify the bobbin is not past the printed
expiration date (EX MM/YY) (Fig. 2). Confirm the bobbin is not
used or damaged by verifying that no white material is missing -
compare to a new one. If you are unsure of the bobbin's condition,
replace it.
7. Bobbin must be installed into the housing (Fig. 13), white side up.
By aligning the slots on the bobbin with the ridges inside the
threaded housing the bobbin will slide in easily.
8. Install the grey cap by screwing clockwise until it meets the
inflator housing shoulder.
NOTE: NO GAP
cylinders only when empty.
2
cylinder by firmly rotating the cylinder
2
12
Publicité
