Mustang Survival MIT 70 Manuel D'utilisation page 13

REARMING (MD4041)
To re-arm your flotation device, you will need Mustang Survival's
Re-Arm Kit (MA4041). The spent inflation parts will first be
removed, and replacement parts will be installed. The re-arm kit
includes:
 17g CO cylinder
2
 Bobbin (which you will not use for MD4041)
WARNING
• Use only with specified PFD/life jacket models.
• The gas (CO
) cylinder is under pressure, therefore misuse can be dangerous.
2
• Avoid prolonged exposure to sunlight, do not store above 120°F (50°C).
• Do not throw into open fire (incinerate) or dump at sea.
• Keep away from children.
• Dispose of CO
• Discharge and dispose of corroded or rusty cylinders.
• Bobbin will dissolve in water.
IMPORTANT: FOLLOW THE INSTRUCTIONS IN THE EXACT SEQUENCE BELOW.
1. Unpack or open the deflated PFD/life jacket (see pg. 9) on a flat
surface and expose the inflator.
2. Remove the cylinder by rotating counterclockwise and then pull
out (see Fig. 8). Discard the used cylinder.
REMOVE CYLINDER
FIGURE 8
3.
Check the manual inflation system to determine that the lever
arm moves freely by moving the lever (attached to the pull tab)
several times down and up. There should be no binding of
mechnanical parts.
cylinders only when empty.
2
ROTATE LEVER
FIGURE 9
10