Promac SX-823DGB Mode D'emploi page 7

Cutting
Capacity
4. FEARTURES:
1. This machine is useful for cutting normal steel, steel pipe, and provides cutting angle at + 60°and -45°by the
swivel head.
2. A tooth selection chart was provided on the machine for cutting reference.
3. Variable speed control gives convenient selection of speeds. (This machine comes with a standard 2-
speed motor. But can be purchased with a variable speed as an option.)
4. This machine is using manual cutting by pulling down the saw bow by hand. Start(press) button is located
at the handle of the saw bow. Motor stops when button was released.
5. Stability of the machine, plus working table height is 950 mm, conforming to human engineering.
6. The one-inch blade and carbide guide provide better result of the cutting surface and efficiency.
7. The one-piece casting and one time CNC processing provide better rigidity and precision of the machine.
8. The one-piece and full coverage blade cover conforms to CE stipulation. Well coolant fluid collection system
provides clean and dry, and safety of the working area.
9. Chip pan underneath the working table prevents coolant fluid leaking and keep floor dry.
10. Coolant for cutting,, water : oil = 40 : 1 oil specification.
5. TRANSPORTATATION & INSTALLATION:
5-1.Unpacking
1. Transportation to desired location before unpacking, please use-lifting jack. (Fig. B)
2. Transportation after unpacking, please use heavy duty fiber belt to lift up the machine.
ALLWAYS KEEP PROPER FOOTING & BALANCE WHILE MOVING THIS MACHINE.
5-2.TRANSPORTATION OF MACHINE:
As this machine weights 320kgs(705.4lbs) it is recommended that the machine be transported with help of lifting jack.
○
(mm)
□
(mm)
0°
(mm)
○
(mm)
□
(mm)
45°
(mm)
○
(mm)
□
(mm)
-60°
(mm)
○
(mm)
□
(mm)
-45°
(mm)
Fig, B
225
200 x 200
240 x 160
145
140 x 140
145 x 115
90
85 x 85
85 x 100
145
140 x 140
145 x 100
8