Promac SX-823DGB Mode D'emploi page 11

Turn (G) to choice the low and high speed.
8.
When saw blade is closing work piece. Or when the cut is completed, the coolant system off
9.
10. Press emergency button (B) to shut-off the motor when in emergent situation.
11. The motor will be stopped when the Frame touch the Limit switch(F).
12. The coolant system will run and stop with blade operation.
13. This handle(H) will not install a switch if your machine is using cylinder
system.
Please use the star switch(E) on the electrical box for star operation.
9-2-2 FOR VARIABLE SPEED
14. Light (D) will be on when power is connected.
15. Rising up the saw arm away from the saw table.
16. Turn right Valve (L) to Close hydraulic valve when in operation.
17. Turn (K) to controlling downwards of saw arm. And control the
downward speed by adjusting hydraulic volume valve.
18. When motor is running, turn right (K), saw arm will automatically go
down and start cutting the work piece. When the cutting is finished,
push button (E) to stop the machine, lift saw arm rise up itself and
close (L), to next reset cutting.
19. Start the motor by turning the start button (C), Push the button (E)
to start blade saw.
7. The coolant system will start as the saw blade operating. The coolant system will stop running as the saw
blade stop operating.
8. Turning (G) to adjust the cutting speed. (Please take the recommend speed reference on the manual)When
saw blade is closing work piece. Or when the cut is completed, turn off the coolant system (A)
9 . Press emergency button (B) to shut-off the motor when in emergent situation.
10. The motor will be stopped when the Frame touch the Limit switch(F).
11. The coolant system will run and stop with blade operation.
12. This handle(H) will not install a switch if your machine is using cylinder system.
Please use the star switch(E) on the electrical box for star operation
9-3.ADJUSTING UPWARD AND DOWNWARD TRAVEL OF SAW ARM
The downward travel of the saw arm should be adjusted so that when the saw arm is in the extreme downward
position, the teeth of the blade will not touch the table surface. The stop screw (N) is used to adjust the distance
between blade and table surface. After the distance is adjusted, tighten lock nut.
.
F
N
12
B
For Variable speed
L
G
E