Publicité
Les langues disponibles
Les langues disponibles
6
Concluding operations
– On vehicles with lane change assist (Audi side assist), this
must be recalibrated ⇒ R ep. gr. 96.
– Connecting the
battery⇒ P age
Note
After reconnecting the power supply, the ESP warning light can
only extinguish after a few metres have been driven.
– Activate the one-touch opening and closing of the electric
window regulators ⇒ vehicle Owner's Manual.
– Retrieve the fault memory for all control units; clear as nec-
essary.
– Keep these assembly instructions with the vehicle docu-
ments so that they can be presented to authorised persons
upon request.
6.1
Adjusting the coding
The required AM code can be found in "ETKA".
– Connect a suitable vehicle diagnostic, measuring and infor-
mation system with online connection to the vehicle.
– When prompted, enter the corresponding code.
– Retrieve the fault memory for all control units; clear as nec-
essary.
– Test towing functions using a suitable tester (with load resis-
tors) or a trailer.
6.2
Function testing
– Check that the electric socket for the tow coupling is working
correctly using a trailer socket tester
ment at the socket for the tow coupling" on page
6.3
Adjusting the cooling system
As trailer operation puts greater demands on the engine cooling
system, the cooling system is upgraded—where technically
possible—when the towing bracket is installed in the factory.
This is achieved by installing a more powerful or second cooling
fan and/or a larger cooler, for instance.
When a towing bracket is retrofitted, the cooling unit should be
upgraded unless this has already been done at the factory. Oth-
erwise, a high engine load (e.g. mountains, high ambient tem-
peratures, high trailer load) could cause the cooling system to
overheat. In the event of an alteration, the parts in the Genuine
Parts catalogue must be used in the engine cooling system dur-
ing trailer operation. The work instructions in the relevant work-
shop manuals must also be observed.
Installation instructions - Audi A8 PU from 2014 ▶
4.
⇒ " Connection assign-
19.
Edition 09.2013
6 Concluding operations
21
Publicité
