Audi 4H0.055.204.C Notice De Montage page 39

– Expose the electrical wiring harness -3, 4-.
– Unscrew nuts -Arrow-.
– Slide the bracket frame -2- upwards and remove from fuse
holder F -SF- -1-.
Installation
Installation is carried out in the reverse of this order. Please
note the following point:
– Insert the bracket frame -2- in a downwards motion into fuse
holder F -SF- -1- and tighten the nuts -arrows- to the tighten-
ing torque.
Tightening torque
Nuts on the bracket frame
4.8 Removing and installing fuse holder F
-SF- in the luggage compartment
Removing
– Unscrew the top right and left nuts on fuse holder F -SF- and
swivel fuse holder F -SF- downwards as far as it will go.
Installation
Installation is carried out in the reverse of this order. Please
note the following point:
– Insert fuse holder F -SF- from below, and tighten the left and
right nuts to the tightening torque.
Tightening torque
Nuts for fuse holder F -SF-
Installation instructions - Audi A8 PU from 2014 ▶
Nm
4
Nm
4
Edition 09.2013
4 Preparations 13