Audi 4H0.055.204.C Notice De Montage page 37

Rear bumper cover gaps:
A - Rear bumper cover to
the bottom of rear lid
● Gap -a- = 5.0 + 0.8 mm
-2- Bumper cover
-3- Rear lid
B - Rear bumper cover to
side of rear lid
● Gap -b- = 3.5 + 0.8 mm
-2- Bumper cover
-3- Rear lid
C - Rear bumper cover to
outside of tail light
● Gap -c- = 1.5 ± 0.7 mm
-2- Bumper cover
-4- Outside tail light
D - Rear bumper cover to
rear side panel
● Gap -d- = invisible joint
-2- Bumper cover
-5- Rear side panel
E - Rear bumper cover to
trim strip
● Gap -e- = invisible joint
-1- Trim strip
-2- Bumper cover
Note
"Equipment variant with SCR system" Installing the active tank
⇒ E ngine, mechanics; Rep. gr. 26.
for reducing agent
Caution
On vehicles with lane change assist, the control unit for the
lane change assist -J769- / -J770- must be recalibrated
Electrical system; Rep. gr. 96.
Installation instructions - Audi A8 PU from 2014 ▶
⇒
Edition 09.2013
4 Preparations 11