Publicité
Les langues disponibles
Les langues disponibles
– Unscrew the screws -arrows- on the lateral support of the
bumper cover -1- and on the lower panel -2- using the plug
insert -T40078-.
– Detach the left and right lateral support -1- of the bumper
cover -2- from the side panel -in the direction of the arrow-.
– Remove rear bumper cover -2-, then disconnect the electri-
cal connectors -3- and -4-.
Installation
Installation is carried out in the reverse of this order. Please
note the following point:
Tightening torques for the rear bumper cover:
Installation instructions - Audi A8 PU from 2014 ▶
Edition 09.2013
4 Preparations
9
Publicité
