Publicité
Les langues disponibles
Les langues disponibles
– For vehicles without the ST 5 fuse carrier installed, attach
the wiring connector to the fuse holder stud bolt -arrow- and
tighten using the nut provided and to the tightening torque
specified.
Tightening torque
Wiring connector to the stud bolt
Note
The illustration shows an empty relay and fuse holder with the
ST 5 fuse carrier installed.
– Insert the fuses provided into the corresponding fuse carrier:
Fuse carrier
Fuse carrier 5 -E-
Fuse carrier 5 -E-
Fuse carrier 5 -E-
Fuse carrier 5 -E-
5.2
Reassembling the vehicle
To install the components, follow the removal steps in reverse
order. Observe the "Notes on installation" for the relevant com-
ponents as well as the corresponding tightening torques.
5.3
Connection assignment at the socket
for the tow coupling
Socket for tow coupling, 13-pin (country variants)
Installation instructions - Audi A8 PU from 2014 ▶
Nm
7.5
Slot
Fuse strength in
amps
2
15A
5
25 A
8
25 A
9
15A
Edition 09.2013
5 Electrical connection
19
Publicité
