Toshiba e-STUDIO2050C Guide D'installation page 2

SET-UP GUIDE
Warnings and Cautionary Points
• The unpacking and setup procedure shall be done by a qualified service technician.
• Be sure to unplug the power cable of the equipment before installing and setting up the product.
• Disconnect the ground wire after unplugging the power cable. In addition, be sure to connect the ground wire
before plugging the power cable.
• Install the equipment near an outlet. Be sure to wire the power cable securely so as to unplug it easily and not
to trip over it.
• According to the equipment model, these illustrations may differ.
• Be sure to secure any optional Large Capacity Feeder (LCF) or Paper Feed Pedestal (PFP) with the
adjusters and confirm that the casters are away from the floor.
• Be sure to clean the adhering surface of the equipment before a seal or part is attached.
• To lift the equipment, be sure to have two people use the handles shown in the figure.
• Install the equipment making sure that the original glass is level.
• Do not remove the tape fixing the platen switch lever until instructed to do so.
• Developer: D-FC30-Y / D-FC30-M / D-FC30-C / D-FC30-K
COMPONENTS:
Iron oxide (1309-37-1), Manganese oxide (1344-43-0), Magnesium oxide (1309-48-4),
Polyester resin, Organic pigment, Carbon black (only D-FC30-K)
- Be careful not to inhale or get developer in your eye.
- If you develop a cough after inhaling developer, get medical attention.
- If developer gets in your eye, wash it out immediately and get medical attention should irritation persist.
© 2012 - 2014 TOSHIBA TEC CORPORATION All rights reserved
P
1 / 21
UIM110081B0 Ver02 F
R111223K5302-TTEC
e-STUDIO2050C/2550C/2051C/2551C